Sebring Sedan L4-2.4L (2007)
Remote Switch: Service and Repair
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury.
1. Disconnect and isolate the battery negative cable.
2. Remove the driver side airbag module from the steering wheel.
3. Remove the speed control switch located on the same side of the steering wheel as the remote radio switch that is being serviced.
4. From the inside of the steering wheel rear trim cover, press firmly and evenly outward on the back of the switch to disengage the four snap features
that secure the switch to the inside of the mounting hole.
5. From the outside of the steering wheel rear trim cover, remove the remote radio switch from the trim cover mounting hole.
