Sebring Sedan L4-2.4L (2007)
10. Remove the screw (1) fastening the wheel speed sensor (2) head in the rear of the hub and bearing. Remove the sensor from the vehicle.
Installation - FWD
FRONT-WHEEL-DRIVE
CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an
open circuit. Be sure that cables are installed, routed, and clipped properly.
1. Install the wheel speed sensor (2) head into the rear of the hub and bearing.
2. Install the wheel speed sensor head mounting screw (1). Tighten the screw to 10 Nm (89 in. lbs.).
