Sebring Sedan L4-2.4L (2007)
Evaporator Temperature Sensor / Switch: Service and Repair
Removal
REMOVAL
NOTE: Illustration shown with air distribution housing removed for clarity.
NOTE: It is not necessary to remove and disassemble the HVAC housing to service the evaporator temperature sensor. The evaporator temperature
sensor can be removed for service from underneath the instrument panel.
1. Disconnect and isolate the negative battery cable.
2. Reach up under the driver side of the instrument panel and disconnect the electrical connector for the evaporator temperature sensor (1) from the
instrument panel wire harness.
3. Using needle nose pliers, disengage the two retaining tabs (3) that secure the evaporator temperature sensor to the HVAC housing (2) by carefully
pulling the sensor straight out of the side of the HVAC housing.
4. Route the electrical connector and wire lead of the evaporator temperature sensor out from under the heater core tubes and remove the sensor from
the vehicle.