Sebring Sedan L4-2.4L (2007)
Impact Sensor: Service and Repair
Front Sensor
Removal
FRONT SENSOR
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this
may result in serious or fatal injury.
2. Remove the screw (4) that secures the front impact sensor (3) to the back of the right or left radiator support vertical member (2).
3. Disconnect the electrical connector (1) from the sensor (3).
4. Remove the front impact sensor from the engine compartment.
Installation
FRONT SENSOR
