Sebring Sedan L4-2.4L (2007)
NOTE: Before removing the front suspension crossmember from the vehicle, the location of the crossmember must be marked on the
body of the vehicle. Do this so the crossmember can be relocated, upon reinstallation, against the body of vehicle in the same location as
before removal. If the front suspension crossmember is not reinstalled in exactly the same location as before removal, the preset front
wheel alignment settings (caster and camber) may be lost.
10. Mark the location of the front crossmember (9) on the body near each mounting bolt.
11. Support the crossmember (9) with a transmission jack.
12. Remove the four mounting bolts (6) securing the front crossmember (9) to the body.
13. Remove the mounting screws (8) securing the front crossmember reinforcement brackets (7) (one each side of vehicle) to the body (1). Remove
the brackets.
14. Slowly lower the crossmember using the jack until there is enough space present to remove the stabilizer bar between the rear of the crossmember
and the body. Due to the fact that the fore-and-aft crossmember is still attached, do not lower crossmember any more than necessary to remove the
stabilizer bar.
15. Remove the screws (1) securing the stabilizer bushing retainers (3) to the crossmember.
16. Remove the two stabilizer bushing retainers (3).
17. Utilizing the slit cut into the cushions (bushings), remove the two cushions from the stabilizer bar.
18. Remove the stabilizer bar (2) from the vehicle.
