Sebring Sedan L4-2.4L (2007)
2.
Disconnect clutch master cylinder pushrod from clutch pedal arm (Fig. 1).
3.
Remove the rubber downstop bumper (Fig. 1).
4.
Push the clutch pedal all the way down.
NOTE:
Be sure the rubber downstop bumper is removed. This will allow for more pedal travel to assist in the next step.
5.
Pull the overcenter spring and bracket bushing out of the pedal arm bracket.
6.
Pry overcenter clutch springs out of both side bushings and discard.
7.
Remove both side bushings and discard.
8.
Release clutch pedal.
9.
Reinstall the rubber downstop bumper.
10. Reconnect the clutch master cylinder pushrod to the clutch pedal arm (Fig. 1).
11.
Install the lower instrument panel bezel.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE: