Sebring Sedan L4-2.4L (2007)
6. Remove the four bolts (1) securing the hub and bearing (2) to the knuckle.
7. Remove the hub and bearing.
Installation
INSTALLATION
NOTE: If equipped, make sure the wheel speed sensor mount on the rear of the hub and bearing is directed toward the front of the vehicle.
1. Position the hub and bearing on the brake support plate and knuckle.
2. Install the four bolts (1) securing the hub and bearing (2) to the knuckle. Tighten the bolts to 105 Nm (77 ft. lbs.).
