Sebring Sedan L4-2.4L (2007)
CAUTION: Gearshift cable bushings must not be lubricated or the bushings will swell and split.
1. Install cable assembly through floor pan opening until grommet is seated.
2. Route transaxle end of cable assembly into engine compartment and over transaxle assembly.
3. Connect cables (1) to the shift levers (3) at the transaxle.
4. Install gearshift cables to mounting bracket (5) and fasten with NEW clips (2). Make sure clips are installed flush to bracket.
5. Install cables (2) to shifter levers (3).
6. Install ORC.
7. Install the air cleaner assembly.
8. Connect battery cables.
