Sebring Sedan L4-2.4L VIN J (2004)
Speaker: Service and Repair
Rear Speaker-JR41
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Fold down the rear seat backs.
3. Remove C-pillar trim.
4. Remove lower quarter trim behind rear seat backs.
5. Remove fasteners from rear shelf trim. Pull out trim to access speaker.
6. Remove speaker screws.
7. Disconnect wire harness connector.
Rear Speaker - JR41
8. Remove speaker.
INSTALLATION
1. Connect wire harness connector to speaker.
2. Position speaker into opening.
3. Install speaker screws. Tighten to 4 Nm (35 in.lbs.).
4. Install rear shelf trim.
5. Install lower quarter trim panel.
6. Install C-pillar trim.
7. Raise seat backs.
8. Connect battery negative cable.
