Sebring Sedan L4-2.4L VIN J (2004)
7.
Raise the vehicle on an appropriate hoist.
8.
Remove the HVAC drain tube from the dash panel by squeezing and pulling on the tube near the dash panel.
9.
Install drain tube adapter, p/n 05191188AA, onto the HVAC drain nipple, (Fig. 1).
10.
Install the revised drain tube, p/n 05264688, onto the drain tube adapter so the down tube is positioned at 7 o'clock when looking toward the rear
of the vehicle.
11.
Seal the opening in the dash panel where the HVAC drain tube passes through with RTV sealer, p/n 82300234.
12.
Lower the vehicle.
13.
After the section dash panel silencer pad has dried determine if there is any objectionable odor. If no odor is detected reuse the original pad. If
there is an objectionable odor, use the original pad cutout as a template to cut replacement pad from p/n 04787422AC.
14.
Adhere the dash panel silencer pad to the floor pan with a small amount of RTV sealer, p/n 04467708, and apply duct tape to the cut seam of the
dash panel silencer pad.
15.
After the carpet has dried determine if there is any objectionable odor. If no odor is detected reuse the original carpet. If there is an objectionable
odor, use the appropriate MOPAR parts catalog to determine the correct replacement carpet.
16.
Use the procedures outlined in TechCONNECT to install the carpet, 23-Body/Interior/Carpets and Floor Mats/Installation.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
