Sebring Sedan L4-2.4L VIN J (2004)
Fig. 6
6. Remove drip rail weatherstrip from vehicle (Fig. 6).
INSTALLATION
1. Place drip rail weatherstrip into position.
2. Push drip rail weatherstrip on to the roof rail pinch flange above door openings.
3. Starting at the bottom of the A-pillar, push the drip rail weatherstrip on to the windshield side molding.
4. Position splash shield.
5. Install two screws.
6. Close front and rear doors.
A - Pillar Weatherstrip Retainer and Molding
A - PILLAR WEATHERSTRIP RETAINER AND MOLDING
REMOVAL
1. Partially raise convertible top.
2. Remove header and A-pillar weatherstrip as necessary to gain access.
Fig. 1
3. Remove screws holding A-pillar weatherstrip retainer to A-pillar (Fig. 1).
4. Remove retainer from vehicle.
5. Remove screws attaching A-pillar molding to A-pillar.
6. Remove A-pillar molding from vehicle.
INSTALLATION
