Sebring Sedan L4-2.4L VIN J (2004)
Control Assembly: Service and Repair
A/C Heater Control - ATC
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG
DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the ash receiver assembly, if necessary.
Instrument Panel Center Trim Bezel Remove/Install
A/C Heater Control Remove/Install
3. Remove the instrument panel center trim bezel and remove the two electrical connectors from the back of the control head and traction control
switch (if equipped).
4. From the back of the center trim bezel, remove the six retaining screws from the a/c heater control head and remove from the bezel.
INSTALLATION
