Sebring Sedan L4-2.4L VIN J (2004)
-
When the switch is fully seated in its bracket, rotate the switch clockwise approximately 30° to lock the switch into place. It should be aligned
straight up and down.
CAUTION: Do not use excessive force when pulling back on the brake pedal to adjust the brake lamp switch. If too much force is used, the
switch or striker can be damaged.
4. Gently release/pull back on the brake pedal until the pedal stops moving. This will ratchet the switch plunger backward to the correct adjustment
position.
5. Check the brake lamps to verify they are operating properly and not staying on when the pedal is in the released position.
