Sebring Sedan L4-2.4L VIN J (2004)
NOTE: The crankshaft sprocket TDC mark is located on the trailing edge of the sprocket tooth. Failure to align trailing edge of sprocket tooth to
TDC mark on oil pump housing will cause the camshaft timing marks to be misaligned.
13. Loosen timing belt tensioner lock bolt (Fig. 105).
14. Insert a 6 mm Allen wrench into the hexagon opening located on the top plate of the belt tensioner pulley (Fig. 105). Rotate the top plate
CLOCKWISE until there is enough slack in timing belt to allow for removal.
15. Remove timing belt.
CAUTION: If timing belt was damaged due to incorrect tracking (alignment), the belt tensioner pulley and bracket must be replaced as an
assembly.
Camshaft Sprockets
1. Disconnect negative battery cable.
2. Remove timing belt.
3. Hold camshaft sprockets with Special Tool 6847 while removing center bolts (Fig. 106).
Crankshaft Sprocket
