Sebring Sedan L4-2.4L VIN J (2004)
Engine Control Module: Testing and Inspection
Pinion Factor Setting
NOTE: This procedure must be performed if the PCM/TCM has been replaced with a NEW or replacement unit. Failure to perform this procedure will
result in an inoperative or improperly calibrated speedometer.
The vehicle speed readings for the speedometer are taken from the output speed sensor. The PCM/TCM must be calibrated to the different combinations
of equipment (final drive and tires) available. Pinion Factor allows the technician to set the Powertrain/ Transmission Control Module initial setting so
that the speedometer readings will be correct. To properly read and/or reset the Pinion Factor, it is necessary to use a DRBIII(R) scan tool.
1. Plug the DRBIII(R) scan tool into the diagnostic connector located under the instrument panel.
2. Select the Transmission menu.
3. Select the Miscellaneous menu.
4. Select Pinion Factor. Then follow the instructions on the DRBIII(R) scan tool screen.
