Sebring Sedan L4-2.4L VIN J (2004)
Evaporator Temperature Sensor / Switch: Description and Operation
Evaporator Temperature Sensor
The evaporator temperature sensor is located at the coldest point on the face of the evaporator. The switch is attached to the evaporator coil with the
sensing probe inserted into the coil fins. The evaporator temperature sensor prevents condensate water on the evaporator coil from freezing and
obstructing A/C system air flow.
Evaporator Temperature Sensor Sensor Set Point
The Body Control Module (BCM) will send a Programmable Communications Interface (PCI) bus message to the Powertrain Control Module (PCM),
which will check engine, coolant temperature, and refrigerant pressure temperature before turning ON the A/C Compressor Clutch. Turning ON the A/C
Compressor Clutch will allow the system to cool the evaporator. The BCM will send a message to the PCM when the evaporator temperature becomes
too cold. The PCM will then turn OFF the A/C Compressor Clutch, before evaporator freeze up occurs. The DRBIII(R) scan tool can be used to monitor
this operation. The temperature set point at which the clutch is turned OFF varies with the outside ambient temperature. The temperature at which the
clutch is turned ON is preset to 2° F above the OFF set point mentioned above. Refer to Evaporator Temperature Sensor Set point table and for the
correct set point.
