Sebring Sedan L4-2.4L VIN X (2001)
CD Changer: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove lower center trim bezel.
3. Remove screws from radio.
Fig.11 CD Changer
4. Remove screws from CD changer.
5. Remove CD changer from Instrument panel.
6. Disconnect wire connector from CD changer.
INSTALLATION
1. Connect wire harness connector to CD changer.
2. Insert CD changer into instrument panel. Make sure that bumper on back of changer is inserted into instrument panel opening.
3. Pull radio from instrument panel far enough to reach behind. Feed CD changer cable through radio opening while inserting changer into
instrument panel.
4. Install screws to radio and CD changer.
5. Install lower center trim bezel.
6. Connect battery negative cable.
