Sebring Sedan L4-2.4L VIN X (2001)
Vacuum Brake Booster: Service and Repair
REMOVAL - POWER BRAKE BOOSTER
1. Remove the remote ground cable from the ground stud located on the left shock tower.
2. Correctly isolate remote ground cable by installing the ground cable insulator on the strut tower ground stud as shown. This will prevent accidental
grounding of the remote ground cable.
3. Disconnect the wiring harness connector and vacuum hose at speed control servo.
4. Remove speed control servo mounting nuts. Leaving cable attached, move servo out off to the side.
5. Remove the master cylinder from the booster.
6. Remove the vacuum hoses from the check valve located on the power brake vacuum booster.
7. Remove the electrical connector and mounting screw from the purge solenoid mounted on the left frame rail. Allow the solenoid to drop
downward.
