Sebring Sedan L4-2.4L VIN X (2001)
Cruise Control Servo: Service and Repair
REMOVAL
Fig.2 Negative Battery Cable
1. Disconnect the negative battery cable.
2. Remove 2 nuts attaching servo bracket to shocktower.
3. Disconnect electrical connectors and vacuum hose.
4. Remove two nuts attaching speed control cable and mounting bracket to servo.
Fig.3 Speed Control Cable And Bracket
5. Pull cable away from servo to expose retaining clip and remove clip attaching cable to servo.
6. Remove servo mounting bracket.
INSTALLATION
1. With throttle in full open position feed cable sleeve through hole in bracket, then align hole in speed control cable sleeve with hole in servo pin
and install retaining clip.
2. Connect vacuum hose to servo.
3. Connect electrical connector.
4. Insert servo studs through holes in speed control cable and mounting bracket.
