Sebring Sedan L4-2.4L VIN X (2001)
the engine.
Upper and lower No. 3 bearing halves are flanged to carry the crankshaft thrust loads and are NOT interchangeable with any other bearing halves in
the engine (Fig. 47). All bearing cap bolts removed during service procedures are to be cleaned and oiled before installation. Bearing shells are
available in standard and the following undersized: 0.016 mm (0.0006 inch), 0.032 mm (0.0012 inch), 0.250 mm (0.010 inch). Never install an
undersize bearing that will reduce clearance below specifications.
INSTALLATION
1. Install the main bearing shells with the lubrication groove in the cylinder block (Fig. 44).
2. Make certain oil holes in block line up with oil hole in bearings and bearing tabs seat in the block tab slots.
CAUTION: Do not get oil on the bedplate mating surface. It will affect the sealer ability to seal the bedplate to cylinder block.
3. Oil the bearings and journals. Install crankshaft.
CAUTION: Use only the specified anaerobic sealer on the bedplate or damage may occur to the engine.
