Sebring Sedan L4-2.4L VIN X (2001)
Fig.5 PCM Bracket
6. Remove PCM from bracket.
7. Remove PCM.
INSTALLATION
The PCM engine control strategy prevents reduced idle speeds until after the engine operates for 320 km (200 miles). If the PCM is replaced after 320
km (200 miles) of usage, update the mileage and vehicle identification number (VIN) in the new PCM. Use the DRB scan tool to change the millage
and VIN in the PCM. If this step is not done a diagnostic trouble code (DTC) may be set arid SKIM must be done or car will not start if it is a SKIM
equipped car. If a SKIM car you must do a secret key transfer also. Refer to the appropriate powertrain Diagnostics and the DRB scan tool.
1. Install PCM to bracket.
2. Install PCM and bracket. Tighten bolt to 4 Nm (35 in. lbs.) torque.
3. Reposition wiring harness.
4. Attach 2 40-way connector to PCM.
5. Connect negative battery cable and reprogram radio and clock.
6. Using DRB III scan tool, program mileage and vehicle identification number (VIN) into PCM. Refer to the DRB III scan tool and the appropriate
Powertrain Diagnostics.
