Sebring Sedan L4-2.4L VIN X (2001)
Fig. 3 Accelerator Pedal
3. Remove nuts from accelerator pedal attaching studs. Remove assembly from vehicle (Fig. 3).
INSTALLATION
1. Position accelerator pedal assembly on dash panel. Install retaining nuts. Tighten retaining nuts to 12 Nm (105 in. lbs.) torque (Fig. 3).
2. From inside the vehicle, hold up the pedal and install the throttle cable and cable retainer in the upper end of the pedal shaft (Fig. 2).
3. From the engine compartment, hold the throttle body lever in the wide open position and install the throttle cable (Fig. 1).
