Sebring Sedan L4-2.4L VIN X (2001)
Fuel Pressure Regulator: Service and Repair
REMOVAL
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE, EVEN WITH ENGINE OFF. BEFORE SERVICING THE
FUEL FILTER/FUEL PRESSURE REGULATOR, THE FUEL SYSTEM PRESSURE MUST BE RELEASED.
1. Refer to Fuel System Pressure Release in the Fuel Delivery System. The fuel filter/fuel pressure regulator is located on the top of fuel pump
module. Fuel pump module removal is not necessary.
2. Raise vehicle on hoist.
3. Remove fuel tank.
4. Disconnect fuel supply line at the Filter/Regulator nipple (refer to Quick Connect Fittings).
Fig. 6 Locking Spring Tab
5. Depress locking spring tab on side of Fuel/Regulator (Fig. 6) and rotate 90° counter-clockwise and pull out.
NOTE: Make sure that the upper and lower O-rings are on the Filter/Regulator assembly.
INSTALLATION
Lightly lubricate the O-rings with engine Oil.
1. Insert Filter/Regulator into the opening in the fuel pump module, align the two hold down tabs with the flange.
Fig. 7 Spring Tab In Locating Slot
2. While applying downward pressure, rotate the Filter/Regulator clockwise until the the spring tab engages the locating slot (Fig. 7).
