Sebring Sedan L4-2.4L VIN X (2001)
Control Module: Service and Repair
Removal and Installation
REMOVAL
NOTE:
-
If the Transmission Control Module (TCM) is being replaced with a new or replacement unit, the Pinion Factor and Quick Learn procedures must
be performed. (Refer to ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - STANDARD PROCEDURE) (Refer
to ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - STANDARD PROCEDURE)
-
If the TCM is being replaced and has recorded less than six hours of PEMCC operation, AND the vehicle has less than 6,035 km (3750 miles),
the Torque Converter Clutch (TCC) Break-In cycle must be restarted (Refer to ELECTRONIC CONTROL MODULES/TRANSMISSION
CONTROL MODULE - STANDARD PROCEDURE)
1. Disconnect battery negative cable at strut tower.
2. Remove air cleaner assembly and transmission control module (TCM)-to-Powertrain Control Module (PCM) bracket nut.
3. Partially remove air cleaner assembly to clear PCM bracket stud.
Fig.9 TCM/Bracket Assembly
4. Remove TCM-to-PDC bracket screw (Fig. 9).
5. Partially remove TCM(mounting bracket assembly and disconnect TCM 60-way connector.
6. Remove TCM(mounting bracket assembly (Fig. 9).
