Sebring Sedan L4-2.4L VIN X (2001)
Seat Belt: Service and Repair
Seat Belt - Rear Outboard
REMOVAL
1. Remove rear seat cushion.
2. Remove bolt attaching seat belt anchor to floor pan.
3. Remove upper and lower quarter trim panel.
4. Remove bolt attaching rear D-ring to quarter upper panel.
5. Remove bolt attaching rear seat belt retractor to inner quarter panel.
6. Remove retractor and belt from vehicle.
INSTALLATION
1. Place retractor and belt into position.
2. Install bolt attaching rear seat belt retractor to inner quarter panel. Torque bolt to 40 Nm (29.5 ft. lbs.).
3. Route seat belt webbing and D-ring through upper trim panel. Install bolt attaching D-ring to quarter panel. Torque bolt to 40 Nm (29.5 ft. lbs.).
4. Install upper quarter trim panel.
5. Install bolt attaching seat belt anchor to floor pan. Torque bolt to 40 .m (29.5 ft. lbs.).
6. Install rear seat cushion.
