Sebring Sedan L4-2.4L VIN X (2001)
5. Remove bolt attaching speed sensor to steering knuckle. Then remove speed sensor head from steering knuckle.
CAUTION: If speed sensor head locating pin has seized to the steering knuckle, do not attempt to remove speed sensor head by grasping with
pliers and turning. This will damage the speed sensor head. Use only the following procedure.
6. If speed sensor head can not be removed from steering knuckle by hand, the locating pin on the speed sensor head has seized to the steering
knuckle do to corrosion. Remove speed sensor head from steering knuckle using the following procedure. Remove disc brake caliper from steering
knuckle, and remove brake rotor from hub/bearing assembly. Then insert a pin punch through hole in front steering knuckle and tap speed sensor
head locating pin out of steering knuckle.
INSTALLATION
This procedure is for the removal and installation of one of the two front wheel speed sensors.
CAUTION: Proper installation of wheel speed sensor cables is critical to continued system operation. Be sure that cables are installed in retainers.
Failure to install cables in retainers as shown in this section may result in contact with moving parts and/or over extension of cables, resulting in an
open circuit.
