Sebring Sedan L4-2.4L VIN X (2001)
REAR LATERAL LINK
1. Install the lateral link and the attaching nut and bolt at rear suspension crossmember. The rear lateral link is to be installed with the adjusting screw
toward rear knuckle not rear suspension crossmember.
2. Install the lateral link and the attaching nut, bolt and washer at rear knuckle.
3. Torque both lateral link attaching bolts to 108 Nm (80 ft. lbs.).
4. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
5. Lower vehicle to the ground.
6. Check and reset rear wheel Camber and Toe to specifications if required.
