Sebring Sedan V6-2.7L (2009)
NOTE: Inspect the brake shoes before installation See: Brake Shoe/Service and Repair/Procedures/Inspection .
9. Install the drum brake shoes (6) and drum (4). Adjust shoes as necessary See: Brake Shoe/Adjustments.
10. Install the tire and wheel assembly (1) See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
11. Slowly rotate the rear wheel and verify that the brake drum lightly drags on the shoes.
12. Lower the vehicle.
13. Remove the brake pedal holding tool.
14. Bleed the affected wheel cylinder as necessary. See: Brake Bleeding/Service and Repair
