Sebring Sedan V6-2.7L (2009)
8. If at any time the adjustment needs to be backed off, perform the following:
a. Remove the plug from the rear of the support plate below the wheel cylinder.
b. Insert a small screwdriver through the access hole (2) in the support plate, under the adjuster, against the lever pawl. The pawl is attached to
and pivots from the rear brake shoe.
c. While pushing on the pawl with the screwdriver to disengage it from the adjuster wheel teeth, rotate the wheel (1) upward to back off the
adjustment using another screwdriver or a brake adjuster tool.
9. Once the shoe diameter is set, remove the tool and install the brake drum (4). See: Brake Drum/Service and Repair/Removal and
Replacement/Installation
10. Turn the brake drum. A slight drag should be felt while rotating the drum. If not, repeat the above procedure.
