Sebring Sedan V6-2.7L (2009)
3. Remove gearshift selector bezel (2) and lamp wiring.
4. Install the gearshift knob set screw (2) and knob (1).
5. Place gearshift lever in the (P) Park position.
6. Loosen the gearshift cable adjuster nut at the shifter assembly.
7. Move the gearshift lever on the transaxle to the Park position.
8. Verify the shift lever and transaxle are in Park position. Tighten the gearshift cable adjuster nut at the shifter assembly. The gearshift linkage
should now be properly adjusted.
9. Check adjustment as follows:
-
Detente position for Neutral and Drive should be within limits of hand lever gate stops.
-
Key start must occur only when shift lever is in Park or Neutral positions.
