Sebring Sedan V6-2.7L VIN R (2004)
Front Door Weatherstrip: Service and Repair
A - Pillar Weatherstrip Retainer and Molding
A - PILLAR WEATHERSTRIP RETAINER AND MOLDING
REMOVAL
1. Partially raise convertible top.
2. Remove header and A-pillar weatherstrip as necessary to gain access.
Fig. 1
3. Remove screws holding A-pillar weatherstrip retainer to A-pillar (Fig. 1).
4. Remove retainer from vehicle.
5. Remove screws attaching A-pillar molding to A-pillar.
6. Remove A-pillar molding from vehicle.
INSTALLATION
1. Clean A-pillar of any seal material residue.
2. Position A-pillar molding to vehicle.
3. Install screws attaching A-pillar molding to A-pillar.
4. Position A-pillar weatherstrip retainer on A-pillar.
5. Install screws attaching retainer to A-pillar. Install middle screw first and then work outward.
6. Install header and A-pillar weatherstrip.
7. Lower and secure convertible top.
