Sebring Sedan V6-2.7L VIN R (2004)
8. Remove header and A-pillar weatherstrip from vehicle.
9. Clean any residual seal material from header panel.
INSTALLATION
Fig. 13
CAUTION: Ensure that the butyl patch and butyl rope at each corner of the windshield is present and in good condition (Fig. 13). The butyl is
critical for the water management system. Replace as necessary.
1. Install new L foam starting at upper screw on A-pillar retainer.
Fig. 14
2. Install new L foam starting at upper screw on A-pillar retainer (Fig. 14).
3. Position header and A-pillar weatherstrip on vehicle.
4. Secure weatherstrip into retainers at header and A-pillar.
5. Install nuts at upper corners of windshield.
6. Install push in fasteners at lower corners of windshield.
7. Install door sill trim panels.
8. Install header trim panel.
9. Install sun visors.
10. Install inside rear view mirror.
11. Lower and secure convertible top.
Outer Door Belt Weatherstrip
