Sebring Sedan V6-2.7L VIN R (2004)
Traction Control Switch: Service and Repair
TRACTION CONTROL SWITCH
REMOVAL
NOTE: Before proceeding, review all WARNINGS and CAUTIONS.
1. Open hood and remove remote ground cable from ground stud on left front shock tower. Isolate ground cable from vehicle by installing cable
isolator on Ground stud (Fig. 12).
2. Remove instrument panel trim bolster below steering column.
3. Disconnect traction control "OFF" switch wiring connector at column harness.
4. Remove 2 screws attaching upper and lower shrouds to steering column (Fig. 13).
5. Remove upper shroud (with switch) from steering column by pressing inward on upper shroud just above the parting line while pulling upper and
lower shrouds apart.
6. Release tilt lever and tilt steering column to its highest point, then remove lower shroud from steering column.
