Sebring Sedan V6-2.7L VIN R (2004)
3. Install the spider assembly to interconnecting shaft retaining snap ring into groove on end of interconnecting shaft (Fig. 28). Be sure the snap ring
is fully seated into groove on interconnecting shaft.
4. Distribute 1/2 the amount of grease provided in the seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into tripod
housing. Put the remaining amount into the sealing boot.
5. Align tripod housing with spider assembly and then slide tripod housing over spider assembly and interconnecting shaft (Fig. 29).
6. Install inner tripod joint seal boot to interconnecting shaft clamp evenly on sealing boot.
