Sebring Sedan V6-2.7L VIN R (2004)
Transmission Speed Sensor: Service and Repair
Input Speed Sensor
REMOVAL
1. Disconnect battery negative cable.
2. If necessary, disconnect and cap off transmission oil cooler lines.
3. Disconnect input speed sensor connector.
4. Unscrew and remove input speed sensor (Fig. 300).
5. Inspect speed sensor O-ring (Fig. 301) and replace if necessary.
INSTALLATION
1. Verify O-ring is installed into position.
2. Install and tighten input speed sensor to 27 Nm (20 ft. lbs.).
3. Connect speed sensor connector.
4. Connect battery negative cable.
