Sebring Sedan V6-2.7L VIN R (2004)
Wiper Motor: Service and Repair
Wiper Motor Assembly Replacement
REMOVAL
1. Disconnect and isolate the battery negative remote cable.
2. Remove wiper arms and blades.
3. Remove the cowl screen.
4. Remove the two wiper motor assembly mounting screws then lift assembly to gain access to wire harness clip.
5. Disconnect harness clip from the forward mounting leg.
6. Disconnect wire connector at motor and remove assembly.
INSTALLATION
1. Connect wire connector at motor.
2. Connect harness clip to the forward mounting leg.
3. Place assembly into position, install the two mounting bolts, and tighten the mounting bolts to 10 to 12 Nm (89 to 106 in. lbs.) torque.
4. Install the cowl screen.
5. Install the wiper arms and blades.
6. Connect the battery negative remote cable.
7. Verify vehicle and system operation.
8. If necessary, adjust wiper arms.
