Sebring Sedan V6-2.7L VIN T FFV (2003)
INSTALLATION
1. Place upper quarter trim panel into position.
2. Route seat belt webbing through access hole in upper quarter trim.
3. Engage clips attaching upper quarter trim to inner quarter panel.
4. On vehicles equipped with side curtain air bag, install the screws and close the screw cap covers.
5. Install bolt attaching rear seat belt anchor to floor.
6. Install rear seat cushion.
7. Install the door opening weatherstrips as necessary.
Rear Door Trim Panel
REMOVAL
1. Open rear door.
2. Lower window.
Fig.7 Rear Door Trim Panel
3. Open the screw cap from bottom of arm rest pull cup and remove the screw.
4. Open the screw cap from behind door latch handle and remove the screw.
5. Remove the screws along the bottom of the trim panel.
6. Using a trim stick C-4755 or equivalent, disengage clips holding perimeter of trim panel to rear door.
7. Remove trim panel from inner belt weatherstrip at top of door.
8. Disconnect wiring harness at door opening.
9. Remove top of trim panel from door.
