Sebring Sedan V6-2.7L VIN T FFV (2003)
Fig.11 Linkage Clip
10. Disengage clip holding linkage to latch handle.
11. Remove linkage from latch handle.
12. Lift trim up and off lock button.
13. Remove rear door trim panel from vehicle.
INSTALLATION
1. Position rear door trim panel on vehicle.
2. Connect linkage to latch handle.
3. Engage clip holding linkage to latch handle.
4. Connect wiring harness at door opening.
5. Position the lock knob through the trim panel and engage trim panel from inner belt weatherstrip at top of door.
6. Align the clips attaching perimeter of trim panel to rear door with the grommets and engage.
7. Install screws attaching door trim panel to door.
8. Install screw holding door latch handle to door and close the screw cap.
9. Install screw from bottom of arm rest pull cup and close the screw cap.
10. Connect battery.
Rear Shelf Trim Panel
REAR SHELF TRIM PANEL
REMOVAL
1. Remove upper quarter trim panels as necessary. Refer to Trim Panel.
2. Fold seat backs down.
