Sebring Sedan V6-2.7L VIN T FFV (2003)
12. Place the ignition key in the ON/RUN position (Fig. 284). Grasp the interlock cable clip and connector. Remove the cable from the interlock
housing (Fig. 285).
13. Remove interlock cable from underside of instrument panel.
INSTALLATION
CAUTION: When installing interlock cable assembly, care must be taken not to bend exposed cable wire and slug at shifter end of cable.
1. Route interlock cable into lower dash panel and towards console as removed.
2. Turn the ignition switch to the ON/RUN position (Fig. 284).
3. Install the interlock cable into the interlock housing at the steering column (Fig. 286). Verify the cable snaps into the housing.
4. Install nylon cable retainer to lower column mounting stud.
5. Connect BTSI solenoid connector.
6. Insert interlock cable core wire into interlock adjustment lever groove. Make sure the interlock cable slug is seated in the groove (Fig. 281).
7. Insert interlock cable adjuster end into bracket and snap into place (Fig. 281).
NOTE: The Interlock Cable MUST be adjusted.
8. Install center console assembly (Fig. 279).
9. Install gearshift bezel (Fig. 277).
10. Install the gearshift knob and tighten set screw (Fig. 277) to 2 Nm (20 inch lbs.).
11. Tilt wheel to full down position and install upper steering column shroud.
12. Install steering column lower shroud (Fig. 283).
13. Install lower knee bo1ster screws and knee bo1ster.
14. Install fuse panel cover (Fig. 282).
15. Connect the battery negative cable.