Sebring Sedan V6-3.5L (2009)
15. Use a thin screw driver and unclip ignition switch from mounting position. Push switch back to remove.
16. Remove the ignition switch/cylinder assembly through the lower steering column opening.
17. Remove WCM retaining screw (1) and flex the retaining tab to release the WCM from the ignition switch.
NOTE: After a SKREEM/WCM is replaced, the ignition/transponder keys need to be programmed to the new SKREEM/WCM. Follow the
directions on the diagnostic scan tool. The transponder key for the SKREES/SKIM and the RKE will both be programmed during
this operation. There is no need to program the fob of the key for RKE functionality once the transponder key is programmed to the
new SKREEM/WCM.
NOTE: When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order:
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Program all ignition/transponder keys to the new SKREEM/WCM See: Keyless Entry/Keyless Entry Module/Testing and Inspection.
