Sebring Sedan V6-3.5L (2009)
Drink Holders: Service and Repair
Heated/Cooled Cupholder Switch - Removal
REMOVAL
1. Disconnect and isolate the negative battery cable.
NOTE: The heated/cooled cupholder switch is secured to the center floor console by four retaining tabs. Two retaining tabs on top and two on
bottom of switch.
2. Using Trim Stick C-4755 (1) or equivalent, disengage the four retaining tabs that secure the heated/cooled cupholder switch (2) to the center floor
console (3).
NOTE: Use care not to allow the wire harness connector for the heated/cooled cupholder switch to fall inside of the center floor console once
the wire harness is disconnected.
3. Remove the heated/cooled cupholder switch from the center floor console and disconnect the wire harness connector from the switch.
