Sebring Sedan V6-3.5L (2009)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: The heated seat switches are integral to the Accessory Switch Bank Module (ASBM) and cannot be serviced separately. The complete
ASBM assembly must be replaced.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel from the instrument panel, See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Bezel - Removal.
3. Remove the four screws (1) that secure the ASBM (2) to the back of the instrument panel center bezel (3) and remove the ASBM.
