Sebring Sedan V6-3.5L (2009)
7. Install the tire and wheel assembly (1) See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
8. Lower the vehicle.
9. Connect the wheel speed sensor cable connector (1) to the body wiring harness connector (2).
10. Reposition the luggage compartment carpet as necessary.
11. Perform the Diagnostic Verification Test and clear any faults. See: Brake Bleeding/Service and Repair
Front-Wheel-Drive
FRONT-WHEEL-DRIVE
CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an
open circuit. Be sure that cables are installed, routed, and clipped properly.
