Sebring Sedan V6-3.5L (2009)
1. Clean all O-ring surfaces on the pump and cover.
2. Apply Mopar(R) Dielectric Grease or the equivalent silicone grease to the O-ring to facilitate assembly. Install a new O-ring on water pump.
3. Position the water pump (3) to engine.
4. Install the mounting bolts and tighten to 12 Nm (9 ft. lbs.).
5. Install the timing belt See: Engine/Timing Components/Timing Belt/Service and Repair/Removal and Replacement/Timing Belt & Sprockets -
Installation.
6. Evacuate air and refill cooling system. See: Procedures
7. Check cooling system for leaks.See: Testing and Inspection/Component Tests and General Diagnostics
