Sebring Sedan V6-3.5L (2009)
10. Hold the left camshaft sprocket with 36 mm (1 7/16 in.) box end wrench.
11. Remove the left camshaft sprocket.
CAUTION: The camshaft must be pushed rearward approximately 3 1/2 inches to remove the camshaft gear retaining bolt and gear. Care
must be taken not to scratch or nick the camshaft or cylinder head journals when moving camshaft.
12. Loosen and remove the right camshaft gear retaining bolt and washer. The right bolt is 213 mm (8 3/8 in.) long.
NOTE: The camshaft timing gears are keyed to the camshaft.
13. Hold the right camshaft sprocket with 36 mm (1 7/16 in.) box end wrench and loosen the camshaft bolt.
14. Using a floor jack, raise the right side of the engine enough to allow clearance to remove the right camshaft bolt and washer.
15. Remove the right camshaft sprocket.
