Sebring Sedan V6-3.5L (2009)
9. Counterhold the cam gear and Install the right cam gear retaining bolt. Tighten the bolt to 102 Nm (75 ft. lbs.) +90° turn.
10. Install the camshaft position sensor. Tighten bolt to 12 Nm (106 in. lbs.).
11. Install the left and right rocker arm and shaft assemblies (2) See: Camshaft, Lifters and Push Rods/Rocker Arm Assembly/Service and
Repair/Removal and Replacement/Valve Rocker Arm - Installation.
12. Install the right (rear) cylinder head cover See: Cylinder Head Assembly/Valve Cover/Service and Repair/Cylinder Head Cover(s) - Installation.
13. Install the left (front) cylinder head cover See: Cylinder Head Assembly/Valve Cover/Service and Repair/Cylinder Head Cover(s) - Installation.
14. Install the ignition coils into the right (rear) cylinder head cover See: Powertrain Management/Ignition System/Ignition Coil/Service and
Repair/Ignition Coil - Installation.
15. Reposition the right (rear) branch of the engine harness, and reconnect the ignition coil harness connectors to the right (rear) bank of ignition coils.
16. Reposition the left (front) branch of the engine harness, and reconnect the ignition coil harness connectors to the left (front) bank of ignition coils.
