Sebring Sedan V6-3.5L (2009)
NOTE: If any foam seal on the air distribution housing outlets is deformed or damaged, the seal must be replaced.
10. Carefully cut the two foam seals (1) along the parting line (2) of the two halves of the air distribution housing (3). If either seal is deformed or
damaged, it must be replaced.
11. Remove the five screws (4) and one metal clip (5) that secure the two halves of the air distribution housing together.
12. Disengage the three plastic retaining tabs (6) that secure the two halves of the air distribution housing together and carefully separate the housing.
NOTE: If a seal on an air door is deformed or damaged, the air door must be replaced.
13. Disengage the air door(s) (1, 2, 3 and 4) from the mode door levers and remove the air doors from the air distribution housing (5).
NOTE: To remove the mode door levers, disengage the retaining tabs on the inside of the air distribution housing and pull the levers straight
out of the housing.
14. Remove the four mode door levers (1, 2, 3 and 4) from the right side of the air distribution housing (5).
