Sebring Sedan V6-3.5L (2009)
2. Remove right front inner wheel splash shield.
3. Use a socket and ratchet to rotate the crankshaft clockwise.
4. While rotating the crankshaft clockwise, walk the power steering drive belt (2) off of the power steering pulley (1).
5. Remove the power steering drive belt (2).
Serpentine Accessory Drive Belt
3.5L
1. Check condition of all pulleys.
CAUTION: When installing the accessory drive belt, the belt MUST be routed correctly. If not, the engine may overheat due to the water
pump rotating in the wrong direction.
2. Install new belt. Route the belt around all pulleys except the idler pulley. Rotate the tensioner arm until it contacts it's stop position. Route the belt
around the idler and slowly let the tensioner rotate into the belt. Make sure the belt is seated onto all pulleys. ON all engines, the tensioner (5) is
equipped with an indexing tang on back of tensioner and an indexing stop on tensioner housing. If a new belt is being installed, tang must
be within approximately 6 - 8mm (0.24 - 0.32 in.) of indexing stop (i.e. tang is approximately between the two indexing stops). Belt is
considered new if it has been used 15 minutes or less.
3. With the drive belt installed, inspect the belt wear indicator.
Serpentine Power Steering Belt
INSTALLATION
