Sebring Sedan V6-3.5L (2009)
11. Connect the A/C discharge line (2) to the A/C compressor (3).
12. Install the nut (1) that secures the A/C discharge line to the A/C compressor. Tighten the nut to 20 Nm (15 ft. lbs.).
13. Install the splash shield onto the right side frame rail See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Splash
Shield - Installation.
14. Lower the vehicle.
15. Reconnect the negative battery cable.
CAUTION: Do NOT run the engine with a vacuum pump in operation or with a vacuum present within the A/C system. Failure to follow this
caution will result in serious A/C compressor damage.
16. Evacuate the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Evacuate.
17. Adjust the refrigerant oil level See: Heating and Air Conditioning/Service and Repair/Refrigerant Oil Level.
18. Charge the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Charge.
