Sebring Sedan V6-3.5L (2009)
If an EDC16-CP31 was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WIN equipped
2. Check PCM/ECM VIN - if NOT WIN equipped
3. Diesel Particulate Filter (Used) Learning
4. NOx Catalyst (New) Initialization
5. Injector Quantity Adjustment
6. IMA Rapid Calibration Test
7. Fuel Mean Value Adaptation Initialization
8. Exhaust Throttle Plate Adaptive Learn Position
If an EDC16-CP31-2 was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WIN equipped
2. Check PCM/ECM VIN - if NOT WIN equipped
3. Injector Quantity Adjustment
4. Program Variant Code
5. ECU Replacement With Value Transfer - if the ECU to be replaced is still responsive
6. ECU Replacement Without Value Transfer - if the ECU to be replaced is NOT responsive
7. Fuel Mean Value Adaptation Initialization
8. IMA Rapid Calibration Test
9. Set Oil Dilution Mass Value
If a CM849 PCM/ECM was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WIN equipped
2. Check PCM/ECM VIN - if NOT WIN equipped
If a CM2100 PCM/ECM was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WIN equipped
2. Check PCM/ECM VIN - if NOT WIN equipped
3. Enable / Disable Vehicle Features - need to enable features
4. Injector Quantity Adjustment
5. Reset Regenerative Filter Timers
6. Mobile DeSoot - NO Minimum Required Soot Load
If an Aisin TCM was replaced, perform the following additional steps and/or routines:
1. Quicklearn
If an EGS TCM was replaced, perform the following additional steps and/or routines:
1. Initialize EGS
If an NGC4 TCM ONLY was replaced, perform the following additional steps and/or routines:
1. Quicklearn
If an NGC3 TCM ONLY was replaced, perform the following additional steps and/or routines:
1. Quicklearn
If an EATX TCM was replaced, perform the following additional steps and/or routines:
1. Quicklearn
STEP-BY-STEP INSTRUCTIONS
Check PCM/ECM VIN
From the "Home" screen, select "ECU View"
-
Select "PCM/ECM"
-
Select "Misc. Functions"
